Caliber L4-2.0L VIN B (2007)
6. Remove the rear center seatbelt retractor retaining bolt (5) from the D-pillar (3).
7. Remove rear center seatbelt retractor (4) from the vehicle.
Installation
INSTALLATION
1. Position rear center seatbelt retractor into hollow in the D-pillar (3).
2. Install the rear center seatbelt retractor retaining bolt (5). Tighten bolt to 40 Nm (29.5 ft. lbs.).
3. Feed seatbelt webbing through upper C-pillar trim panel.
4. Install the upper C-pillar trim panel.
5. If replacing the seatbelt into the latch stowage, place into slot and push down.
