Caliber L4-2.0L VIN B (2007)
1. Position the sensor onto the B-pillar and install the mounting screw (1). Tighten the screw to 8 Nm (71 in. lbs.).
NOTE: Be certain that the anti-rotation pin on the back of the sensor is engaged in the hole just below the mounting hole in the B-pillar (3).
2. Connect the harness connector (4) to the sensor (2).
3. Install the B-pillar lower trim panel.
WARNING: Do not connect the battery negative cable. Personal injury or death may result if the system test is not performed first.
Side - C-Pillar
SIDE - C-PILLAR
1. Position the side impact sensor near the inner C-pillar.
2. Connect the harness connector (2) to the sensor (3).
3. Position the sensor onto the C-pillar.
NOTE: Be certain that the anti-rotation pin on the back of the sensor is engaged in the clearance hole on the C-pillar below the sensor mounting
hole.
4. Install screw (4) that secures the sensor (3) to the C-pillar (1). Tighten the screw to 8 Nm (71 in. lbs.).
5. Install the rear quarter panel trim.
WARNING: Do not connect the battery negative cable. Personal injury or death may result if the system test is not performed first.
