dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Steering - ESP Lamp On Possible DTC C121A/C2205|Page 7168 > < Steering - ESP Lamp On Possible DTC C121A/C2205|Page 7162
Page 1
background image

Steering Angle Sensor: Technical Service Bulletins
Steering - ESP Lamp On Possible DTC C121A/C2205

NUMBER: 08-010-07

GROUP: Vehicle Performance

DATE: May 17, 2007

THE StarSCAN(R) FLASH FILES FOR THIS BULLETIN ARE AVAILABLE VIA THE INTERNET.

SUBJECT:
FLASH: DTC's C121A / C2205 - Steering Angle Sensor - Not Initialized / Internal

OVERVIEW:

This bulletin involves selectively erasing and reprogramming the Steering Angle Sensor (SAS) with new software.

MODELS:

2007

(JK)

Wrangler

2007

(JS)

Sebring

2007

(KA)

Nitro

2007

(MK49)

Compass

2007

(MK74)

Patriot

2007

(PM)

Caliber

NOTE:

This bulletin applies to vehicles built on or before April 12, 2007 (MDH 0412XX).

SYMPTOM/CONDITION:

The vehicle operator may experience an illumination of the Electronic Stability Program (ESP) lamp on the vehicle instrument cluster. The ESP lamp
illumination may be due to the following Diagnostic Trouble Codes (DTC's):

C121A - Steering Angle Sensor Not Initialized C2205 - Steering Angle Sensor Internal

This condition, and DTC's, may be intermittent. If the above DTC's occur during a drive cycle, then the ESP lamp will remain illuminated until the end
of that drive cycle (key off).

DIAGNOSIS:

Using a StarSCAN(R) with the appropriate Diagnostic Procedures available in TechCONNECT, verify all engine systems are functioning as designed. If
DTCs are present record them on the repair order and repair as necessary before proceeding further with this bulletin.

If the vehicle operator describes or experiences the Symptom/Condition, perform the Repair Procedure.

Steering - ESP Lamp On Possible DTC C121A/C2205|Page 7168 > < Steering - ESP Lamp On Possible DTC C121A/C2205|Page 7162