Caliber L4-2.0L VIN B (2007)
3. Position the shock assembly (2) in the strut spring compressor (1) following the manufacturer's instructions and set the lower and upper hooks of
the compressor on the coil spring.
4. Compress the coil spring until all spring tension is removed from the upper mounting bracket and bushings.
CAUTION: Never use impact or high speed tools to remove the shock rod nut. Damage to the shock internal bearings can occur.
5. Once the spring is sufficiently compressed, install Snap-On(R) Shock Absorber Socket A139, or equivalent, on the end of the shock rod (1). While
holding the shock rod from turning, remove the nut (2) using a wrench. Remove the washer below the nut.
