Caliber L4-2.4L (2009)
6. Position the power steering pressure hose routing clamp (2) on the exhaust manifold and install the mounting screw (1). Tighten the mounting
screw to 9 Nm (80 in. lbs.).
7. Push the brake tube bundle routing clips (with tubes) onto the studs on the dash panel.
8. Install the heat shield on the dash panel and tighten the lower and upper mounting nuts.
9. Remove the brake pedal holding tool.
10. Install the engine appearance cover.
11. Connect the battery negative cable to the battery post. It is important that this be performed properly. See: Starting and Charging/Battery/Service
and Repair/Procedures/Battery Reconnection
12. Hook up the scan tool to initialize the ABM and perform the following:
a. Clear any faults.
b. Fill the master cylinder to the proper fill level and bleed the base and ABS hydraulic systems. See: Brake Bleeding/Service and Repair
c. Check for leaks.
d. Perform the ABS Verification Test, See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures/Verification Tests/ABS Verification Test and road test the vehicle.
Hydraulic Control unit (HCU) - Removal
REMOVAL
To remove the HCU, the ICU must be removed and disassembled. See: Integrated Control Unit (ICU) - Removal See: Overhaul/Integrated Control Unit
(ICU) - Disassembly
