Caliber L4-2.4L (2009)
1. Install the wheel cylinder onto the brake support plate. Install and tighten the mounting screws (1) to 13 Nm (115 in. lbs.).
2. Hand start the brake tube nut (2) into the wheel cylinder (1). Tighten the tube nut to 17 Nm (150 in. lbs.).
NOTE: Inspect the brake shoes before installation. See: Drum Brake System/Brake Shoe/Service and Repair/Procedures/Inspection
3. Install the drum brake shoes (6) and drum. Adjust shoes as necessary. See: Drum Brake System/Brake Shoe/Service and Repair/Removal and
Replacement/Installation
4. Install the tire and wheel assembly (1) See: Maintenance/Wheels and Tires/Service and Repair/Removal and Replacement/Tires and Wheels -
Installation. Install and tighten the wheel mounting nuts (3) to 135 Nm (100 ft. lbs.).
5. Slowly rotate the rear wheel and verify that the brake drum lightly drags on the shoes.
6. Lower the vehicle.
