Caliber L4-2.4L (2009)
Wiper Switch: Service and Repair
Right Multifunction Switch - Installation
INSTALLATION
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper
precautions could result in accidental airbag deployment.
1. Position the right multi-function switch (2) close enough to the mounting bracket (3) integral to the right side of the clockspring to reconnect the
jumper wire harness connector (1) to the connector receptacle on the inboard side of the switch housing.
2. Align the slide tab on the bottom of the switch housing with the channel integral to the clockspring mounting bracket, then slide the switch into the
bracket until it is firmly seated.
3. Install and tighten the screw (2) that secures the mounting tab on the back of the right multi-function switch (1) to the mounting bracket on the
clockspring (3).
4. Reinstall the upper and lower shrouds onto the steering column. See: Steering and Suspension/Steering/Steering Column/Steering Column
Cover/Service and Repair/Steering Column Shroud - Installation and See: Steering and Suspension/Steering/Steering Column/Steering Column
Cover/Service and Repair/Steering Column Shroud - Installation.
5. Reconnect the battery negative cable.
