Caliber L4-2.4L (2009)
9. Install the tire and wheel assembly (1) See: Wheels and Tires/Service and Repair/Removal and Replacement/Tires and Wheels - Installation.
Install and tighten the wheel mounting nuts (3) to 135 Nm (100 ft. lbs.).
10. Perform the above procedure to opposite strut as required.
11. Lower the vehicle and jounce the front and rear of the vehicle.
12. Adjust the front camber to the preferred setting by pushing or pulling on the top of the tire. When camber is set to specifications, tighten the upper
and lower strut clevis-to-knuckle attaching bolt nuts (3, 4) enough to hold the adjustment. Again jounce the front and rear of the vehicle, then
verify the camber settings.
13. Tighten the front strut clevis-to-knuckle attaching bolt nuts (3, 4) to 110 Nm (81 ft. lbs.).
14. Once camber is within specifications, adjust toe to meet the preferred specification setting. Refer to FRONT TOE within this wheel alignment
service procedure.
TOE
1. Center the steering wheel and lock it in place using a steering wheel clamp.
NOTE: When setting toe, make sure to set rear toe to the preferred specifications before setting front toe to the preferred specifications
REAR TOE
NOTE: Perform the following at each rear wheel as necessary.
