Caliber L4-2.4L (2009)
18. Remove the four nuts (4) attaching the power brake booster (3) to the dash panel.
19. Slide the power brake booster (3) forward until its mounting studs clear the dash panel, then remove it through the engine compartment.
CAUTION: Brake fluid will damage painted surfaces. If brake fluid is spilled on any painted surfaces, wash it off immediately with water.
20. Disconnect hydraulic tube (6) at the clutch master cylinder pressure line connector (5) by pulling retaining clip then pulling out on tube. Cap off
hydraulic tube to prevent fluid loss. To completely drain clutch master cylinder and tubing, remove brake master cylinder cap and drain fluid into
suitable container.
21. Disconnect clutch master cylinder pushrod (3) from clutch pedal.
22. Remove master cylinder assembly (4) from mounting position by turning 1/4 turn clockwise.
