Caliber L4-2.4L (2009)
5. Distribute 1/2 the amount of grease provided in seal boot service package (DO NOT USE ANY OTHER TYPE OF GREASE) into outer CV joint
assembly housing. Put the remaining amount into the sealing boot (4).
6. Install outer CV joint sealing boot to interconnecting shaft clamp evenly on sealing boot.
7. Clamp sealing boot onto interconnecting shaft (2) using crimper, Clamp C-4975A and the following procedure. Place Clamp C-4975A (1) over
bridge of clamp (3).
8. Tighten nut on Clamp C-4975A until jaws on tool are closed completely together (2), face to face.
CAUTION: Seal must not be dimpled, stretched, or out-of-shape in any way. If seal is NOT shaped correctly, equalize pressure in seal and
shape it by hand.
9. Position outer CV joint sealing boot (4) into its retaining groove on outer CV joint housing. Install sealing boot to outer CV joint retaining clamp
(1) evenly on sealing boot.
10. Clamp sealing boot onto outer CV joint housing using Clamp C-4975A (3) and the following procedure. Place Clamp C-4975A over bridge of
clamp (1).
