Caliber L4-2.4L (2009)
Wheel Bearing: Service and Repair
Rear Hub and Bearing - Installation
FRONT-WHEEL-DRIVE
NOTE: If equipped, make sure the wheel speed sensor mount on the rear of the hub and bearing is directed toward the front of the vehicle.
1. Position the hub and bearing on the brake support plate and trailing link.
2. Install the four bolts (1) securing the hub and bearing (2) to the trailing link. Tighten the bolts to 105 Nm (77 ft. lbs.).
NOTE: Before installing the wheel speed sensor head (3) into the rear of the hub and bearing (2), inspect the O-ring seal to make sure it is not
dislodged, split, cut or damaged in any way. Replace the O-ring as necessary.
3. If equipped with a wheel speed sensor, install the wheel speed sensor head (3) into the rear of the hub and bearing (2).
4. If equipped with a wheel speed sensor, install the wheel speed sensor head mounting screw (1). Tighten the screw to 10 Nm (89 in. lbs.).
