Caliber SRT-4 L4-2.4L Turbo VIN F (2007)
7.
Remove interior trim flag for outside mirror, disconnect wire harness to electric mirror, (if equipped).
8.
Using trim stick, remove speaker cover.
9.
Remove top front and lower rear speaker screws only, (T-20 Torx). (Speaker will stay with door module).
10.
Remove bolt(s), (10 mm hex), retaining door module near speaker:
a.
MK: 2 bolts.
b.
PM: 1 bolt.
11.
Remove (2) longer bolts, (10 mm hex), retaining door module at bottom of door module.
12.
Remove trim cap and screw, (T-20 Torx), at inside door pull cup.
13.
Using trim stick, release bolster, swing down and allow to hang by tethers.
14.
Release both window latches on regulator, pull up and roll back of window up to remove from door from the outside of door. Set glass aside on
protected surface.
15.
Remove bolts, (10 mm hex), behind bolster, (2 in regulators and 1 at center of door module).
16.
Disconnect linkages at door latch to:
a.
Outside door handle, (both sides of vehicle).
b.
Lock cylinder, (drivers side only).
17.
Remove (3) screws, (T-30 Torx), retaining latch to door.
18.
Maneuver door module up, then forward, then down to remove from door.
19.
Place removed door module face down on a clean, protected surface.
