Caliber SRT-4 L4-2.4L Turbo VIN F (2007)
6. Bleed the remaining wheel circuits in the same manner until all air is removed from the brake system. Monitor the fluid level in the master cylinder
reservoir (2) to make sure it does not go dry.
7. Check and adjust brake fluid level to the FULL mark.
8. Check the brake pedal travel. If pedal travel is excessive or has not been improved, some air may still be trapped in the system. Re-bleed the
brakes as necessary.
9. Test drive the vehicle to verify the brakes are operating properly and pedal feel is correct.
PRESSURE BLEEDING
NOTE: Follow pressure bleeder manufacturer's instructions for use of pressure bleeding equipment.
1. Attach Master Cylinder Cap (2), Special Tool 6921, in place of the filler cap on the master cylinder reservoir (3).
2. Attach Bleeder Tank (1), Special Tool C-3496-B, or an equivalent, to the Master Cylinder Cap 6921.
