Caliber SRT-4 L4-2.4L Turbo VIN F (2007)
7. Pump the brake pedal several times before moving the vehicle to set the pads to the brake rotor.
8. Check and adjust the brake fluid level in the reservoir (2) as necessary.
9. Road test the vehicle and make several stops to wear off any foreign material on the brakes and to seat the brake pads.
Removal
REMOVAL
NOTE: Refer to Warnings and Cautions.
NOTE: If the rear brake pads are being replaced due to a howl or moan while driving in reverse, proper diagnosis and correction is essential.
1. Raise and support the vehicle.
NOTE: Perform STEP 2 through STEP 6 on each side of the vehicle to complete pad set removal.
2. Remove the wheel mounting nuts (3), then the tire and wheel assembly (1).
NOTE: In some cases, it may be necessary to retract the caliper piston in its bore a small amount in order to provide sufficient clearance
between the pads and the rotor to easily remove the caliper from the knuckle. This can usually be accomplished before the guide pin bolts
are removed, by grasping the rear of the caliper and pulling outward working with the guide pins, thus retracting the piston. Never push
on the piston directly as it may get damaged.
