Caliber SRT-4 L4-2.4L Turbo VIN F (2007)
5. Remove the inboard brake pad (5) from the caliper adapter bracket (3).
6. Remove the outboard brake pad (2) from the caliper (1) by prying the brake pad retaining clip over the raised area on the caliper. Slide the brake
pad off of the brake caliper.
Installation
INSTALLATION
NOTE: If the rear pads are being replaced due to a howl or moan while driving in reverse, proper diagnosis and correction is essential.
NOTE: Perform STEP 1 through STEP 6 on each side of the vehicle to complete pad set installation, then proceed to STEP 7.
1. Completely retract the caliper piston back into the piston bore of the caliper. This is required to gain the necessary pad-to-rotor clearance for the
caliper installation onto the steering knuckle.
NOTE: Place the brake pad with the audible wear indicator attached on the inboard side. The audible wear indicator should be
positioned at the bottom when installed.
