Caliber SRT-4 L4-2.4L Turbo VIN F (2007)
6. If equipped with a manual transaxle and a new reservoir is being installed, using an appropriate cutting tool, cut the clutch actuator port at the
center of the "V" groove (2) opening the hydraulic clutch port (1). Discard the severed plug (3).
7. If equipped with a manual transaxle, slide the clutch actuator hose (2) onto the reservoir port (1). Install the hose clamp just past the upset bead on
the port.
8. Connect the primary (1) and secondary (2) brake tubes to the master cylinder outlet ports. Tighten the tube nuts to 17 Nm (150 in. lbs.).