Caliber SRT-4 L4-2.4L Turbo VIN F (2007)
6. Position the power steering pressure hose routing clamp (2) on the exhaust manifold and install the mounting screw (1). Tighten the mounting
screw to 9 Nm (80 in. lbs.).
7. Push the brake tube bundle routing clips (with tubes) onto the studs on the dash panel.
8. Install the heat shield on the dash panel and tighten the lower and upper mounting nuts.
9. Remove the brake pedal holding tool.
10. Install the engine appearance cover.
11. Connect the battery negative cable to the battery post. It is important that this be performed properly.
