Caliber SRT-4 L4-2.4L Turbo VIN F (2007)
Parking Brake Cable: Service and Repair
Installation
INSTALLATION
NOTE: The following procedure applies to either of the two rear parking brake cables.
1. From underneath, push the parking brake cable through the hole (8) in the floor pan of the vehicle making sure the cable sealing grommet (6) is
installed in the floor pan as far as possible (without going all the way through) to ensure a good seal.
2. Position the cable routing clamp (3) over the stud on the fuel tank strap (7) and install the nut (5).
3. Position the cable routing clamp (3) and install the screw (4) securing the cable (1 - right cable, 9 - left cable) to the body (2).
4. Insert the parking brake cable through the hole in the trailing link and the support plate (3).
5. Install the hair pin (1) securing the parking brake cable (2) to the brake support plate (3).
6. Install the parking brake shoes (and check adjustment) and components removed to access them.
