Caliber SRT-4 L4-2.4L Turbo VIN F (2007)
Drive Belt: Removal and Replacement
Removal
GAS ENGINE
1. Using a wrench, rotate accessory drive belt tensioner (8) counterclockwise until accessory drive belt (2) can be removed from pulleys (5 and 9).
2. Remove accessory drive belt (2).
Installation
GAS ENGINE
NOTE: When installing drive belt on the pulleys, make sure that belt is properly routed and all V-grooves make proper contact with pulley
grooves.
1. Install the accessory drive belt (2) around all the pulleys except for the generator pulley (3).
