Caliber SRT-4 L4-2.4L Turbo VIN F (2007)
Engine Mount: Service and Repair
Rear Mount
Removal
REMOVAL
1. Remove rear mount retaining bolts (4).
2. Remove rear mount through bolt (1).
3. Remove oxygen sensor connector (2) from mount.
4. Remove rear mount (3).
Installation
INSTALLATION
1. Position rear mount (3).
2. Install rear mount retaining bolts (4) and torque to 50 Nm (37 ft. lbs.).
3. Install rear mount through bolt (1) and torque to 75 Nm (55 ft. lbs.).
4. Install oxygen sensor connector (2) retainer to mount (3).
