Caliber SRT-4 L4-2.4L Turbo VIN F (2007)
NOTE: LHD model shown. RHD model similar.
7. Remove the left and right side instrument panel and demister ducts (1 and 2).
8. Remove the two screws (3) that secure the center instrument panel duct (4) to the instrument panel support.
9. Rotate and tilt the center duct as necessary to remove it from the instrument panel.
Installation
INSTALLATION
NOTE: Illustrations shown with instrument panel removed from vehicle for clarity.
LEFT AND RIGHT SIDE DUCT
NOTE: The left and right side instrument panel ducts are serviced only as an assembly with the left or right side demister duct.
NOTE: LHD model shown. RHD model similar.
1. Position the left and right side instrument panel ducts (7 and 10) and the left and right side demister ducts (1 and 6) onto the top of the instrument
panel as assemblies.
2. Connect the left and right side instrument panel ducts to the center duct (9). Make sure the ducts are fully engaged to each other.
3. Install the push-pin fastener (8) that secures each instrument panel duct to the instrument panel support.
4. Install the screws (2) that secure each demister duct to the instrument panel support. Tighten the screws to 2.2 Nm (20 in. lbs.).
5. Connect the left and right side demister hoses (3 and 5) to the defroster duct (4). Make sure the hoses are fully engaged to the defroster and
demister ducts.
