Caliber SRT-4 L4-2.4L Turbo VIN F (2007)
3. Slide the lamp housing rearward far enough to obtain clearance between the front edge of the lamp housing and the front of the headliner mounting
hole for the lamp.
4. Depress the two spring tabs (2) far enough to push the forward edge of the lamp housing up into the mounting hole in the headliner, then release
the spring tabs to engage the back of the headliner substrate.
5. Align the snap clip retainer (3) with the hole in the upper liftgate opening header.
6. Press firmly and evenly upward on the center of the flashlight receptacle in the cargo lamp housing (1) until the snap clip retainer on the back of
the lamp snaps into place in the hole in the upper liftgate opening header (3).
7. Reinstall the push pin fastener (4) adjacent to each side of the cargo lamp that secures the headliner (5) to the upper D-pillar reinforcement (2).
8. Reinstall the trim onto the inside of both upper D-pillars.
9. Reinstall the flashlight into the cargo lamp housing.
10. Reconnect the battery negative cable.
Lamp - Without Flashlight Feature
LAMP - WITHOUT FLASHLIGHT FEATURE
NOTE: There are two types of cargo lamps available in this vehicle; one with and one without a removable flashlight feature.
1. Position the cargo lamp unit (1) to the mounting hole in the headliner.
2. Reconnect the wire harness connector to the connector receptacle on the back of the lamp housing.
3. Insert the fixed retainer (4) on the notched end (5) of the lamp housing up into one side of the mounting hole in the headliner.
