Caliber SRT-4 L4-2.4L Turbo VIN F (2007)
Headlamp Bulb: Service and Repair
Installation
BULBS
1. Reaching up through wheel well, install the headlamp or park/turn signal bulb (1) in the front lamp unit, locking it into place by twisting a 1/4 turn
clockwise.
NOTE: EXPORT ONLY - If installing/replacing the headlamp bulb on export vehicles push the bulb straight in unit and then install the spring
clip. Install the rubber cover over the rear of the lamp housing, over the headlamp bulb.
2. Connect the bulb electrical connector (2 or 3).
3. Install the front of the splash shield (6) removed to gain access to the front lamp unit bulbs.
4. Lower vehicle from hoist.
5. Connect the battery negative cable.
