Caliber SRT-4 L4-2.4L Turbo VIN F (2007)
1. If removed, install the A/C pressure transducer (2) onto the A/C discharge line (3). Tighten the A/C pressure transducer securely.
2. Position the A/C discharge line into the engine compartment.
3. Remove the tape or plugs from the discharge line fitting and the condenser port.
4. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it and a new gasket onto the discharge line fitting. Use only the specified
O-ring as it is made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the
vehicle.
5. Reach down through the opening between the radiator and the front fascia and connect the A/C discharge line to the A/C condenser (4).
6. Install the nut (5) that secures the A/C discharge line to the A/C condenser. Tighten the nut to 5 Nm (44 in. lbs.).
7. Connect the wire harness connector (1) to the A/C pressure transducer.
8. Install the upper radiator closure panel.
9. Raise and support the vehicle.