Caliber SRT-4 L4-2.4L Turbo VIN F (2007)
26. Remove the tape or plugs from the suction line fitting and the accumulator port.
27. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it and new gasket onto the suction line fitting. Use only the specified
O-ring as it is made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the
vehicle.
28. Connect the lower A/C suction line (3) to the A/C accumulator (1).
29. Install the nut (2) that secures the lower A/C suction line to the A/C accumulator. Tighten the nut to 5 Nm (44 in. lbs.).
30. Reposition the front of the right front wheel house splash shield (3) to the body (4) and install the three push-pin retainers (1) and the three screws
(2). Tighten the screws securely.
31. Install the right front wheel.
32. Lower the vehicle.
33. Reconnect the negative battery cable.
