Caliber SRT-4 L4-2.4L Turbo VIN F (2007)
Manifold Pressure/Vacuum Sensor: Description and Operation
Operation
OPERATION
The MAP serves as a PCM input, using a silicon based sensing unit, to provide data on the manifold vacuum that draws the air/fuel mixture into the
combustion chamber. The PCM requires this information to determine injector pulse width and spark advance. When MAP equals Barometric pressure,
the pulse width will be at maximum.
Also like the cam and crank sensors, a 5 volt reference is supplied from the PCM and returns a voltage signal to the PCM that reflects manifold pressure.
The zero pressure reading is 0.5 volt and full scale is 4.5 volt. For a pressure swing of 0 - 15 psi the voltage changes 4.0 volt. The sensor is supplied a
regulated 4.8 to 5.1 volts to operate the sensor. Like the cam and crank sensors ground is provided through the sensor return circuit.
The MAP sensor input is the number one contributor to pulse width. The most important function of the MAP sensor is to determine barometric pressure.
The PCM needs to know if the vehicle is at sea level or is it in Denver at 5000 feet above sea level, because the air density changes with altitude. It will
also help to correct for varying weather conditions. If a hurricane was coming through the pressure would be very, very low or there could be a real fair
weather, high pressure area. This is important because as air pressure changes the barometric pressure changes. Barometric pressure and altitude have a
direct inverse correlation, as altitude goes up barometric goes down. The first thing that happens as the key is rolled on, before reaching the crank
position, the PCM powers up, comes around and looks at the MAP voltage, and based upon the voltage it sees, it knows the current barometric pressure
relative to altitude. Once the engine starts, the PCM looks at the voltage again, continuously every 12 milliseconds, and compares the current voltage to
what it was at key on. The difference between current and what it was at key on is manifold vacuum.
During key On (engine not running) the sensor reads (updates) barometric pressure. A normal range can be obtained by monitoring known good sensor
in your work area.
As the altitude increases the air becomes thinner (less oxygen). If a vehicle is started and driven to a very different altitude than where it was at key On
the barometric pressure needs to be updated. Any time the PCM sees Wide Open throttle, based upon TPS angle and RPM it will update barometric
pressure in the MAP memory cell. With periodic updates, the PCM can make its calculations more effectively.
The PCM uses the MAP sensor to aid in calculating the following:
-
Barometric pressure
-
Engine load
-
Manifold pressure
-
Injector pulse-width
-
Spark-advance programs
-
Shift-point strategies (F4AC1 transmissions only, via the PCI bus)
-
Idle speed
-
Decel fuel shutoff
The PCM recognizes a decrease in manifold pressure by monitoring a decrease in voltage from the reading stored in the barometric pressure memory
cell. The MAP sensor is a linear sensor; as pressure changes, voltage changes proportionately. The range of voltage output from the sensor is usually
between 4.6 volts at sea level to as low as 0.3 volts at 88 kPa (26 in. Hg). Barometric pressure is the pressure exerted by the atmosphere upon an
object. At sea level on a standard day, no storm, barometric pressure is 101 kPa (29.92 in. Hg). For every 30.5 meters (100 feet) of altitude barometric
pressure drops .33 kPa (0.10 in. Hg). If a storm goes through it can either add, high pressure, or decrease, low pressure, from what should be present for
that altitude. You should make a habit of knowing what the average pressure and corresponding barometric pressure is for your area.
