Caliber SRT-4 L4-2.4L Turbo VIN F (2007)
1. Position the TIPM in the engine compartment.
2. Align the TIPM on its mounting bracket and install.
3. Route the engine compartment wire harness from the TIPM through the engine compartment, engaging each of the harness retainers to the
mounting provisions in the vehicle body and chassis components. Refer to Wiring Diagrams for the harness routing and retainer locations.
4. Install and tighten the fasteners that secure each of the engine compartment wire harness ground eyelets to the vehicle body and chassis
components. Refer to Wiring Diagrams for the ground eyelet locations.
5. Reconnect each of the engine compartment wire harness connectors. Refer to Wiring Diagrams for the locations of the affected connectors.
6. Torque nut retaining positive battery cable at TIPM to 96 - 141 Nm (85 - 130 in. lbs.).
7. Reconnect the battery negative cable.
8. Close hood.
9. Verify vehicle and system operation.
