Caliber SRT-4 L4-2.4L Turbo VIN F (2007)
NOTE: It is not necessary to remove the knee blocker airbag (1) from the instrument panel (2) all the way. After loosening the two nuts (3) to the
instrument panel there should be enough room to unlatch the trim cover (5).
1. Open hood, disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component
service. Failure to do so may result in accidental airbag deployment, personal injury or death.
2. Remove the two lower knee blocker airbag trim cover screws (4).
3. Reach up behind the knee blocker airbag (1) and remove the two nuts (3) holding the airbag to the instrument panel (2).
4. Pull the knee blocker airbag rearward enough to undo the hook and latch retainers to the airbag trim cover (5).
Installation
INSTALLATION
1. Slide the airbag trim cover over the hook and latch retainers on the knee blocker airbag (1).
2. Push the airbag forward.
3. Reach up behind the instrument panel and install the two knee blocker airbag retaining nuts. Tighten nuts to 10.5 Nm (93 in. lbs.).
4. Install the two knee blocker airbag cover screws (4).
WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE. PERSONAL INJURY OR DEATH MAY RESULT IF THE
SYSTEM TEST IS NOT PERFORMED FIRST. FOR THE SYSTEM TEST, See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Supplemental Restraints
Verification Test
