Caliber SRT-4 L4-2.4L Turbo VIN F (2007)
Air Bag Control Module: Service and Repair
Removal
REMOVAL
1. Open hood.
2. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component
service. Failure to do so may result in accidental airbag deployment, personal injury or death.
3. Remove the floor shifter bezel (1).
4. It is necessary to lift up but not remove on the jute covered panel (1) covering the ORC (2).
