Caliber SRT-4 L4-2.4L Turbo VIN F (2007)
WARNING: Due to the integral tensioners, the front seat belt retractor assemblies must be replaced following a collision where the airbags
were deployed.
1. Position the front seat belt retractor (1) into B-pillar pocket.
2. Connect electrical connectors. One is for the tensioner squib (2) and the other is for the seat belt switch (3).
3. Install the anchor bolt (6) to the lower B-pillar (1). Tighten bolt to 40 Nm (29.5 ft. lbs.).
4. Install the seatbelt webbing guide into the B-pillar (1).
5. Install the lower B-pillar trim and upper B-pillar trim (3).
6. Install the bolt (4) attaching the turning loop to the belt height adjuster (2). Tighten bolt to 40 Nm (29.5 ft. lbs.).
