Caliber SRT-4 L4-2.4L Turbo VIN F (2007)
11. Remove the fasteners (1) securing the power steering hose routing clamps (2) to the crossmember.
12. Remove the power steering pressure hose from the vehicle.
Installation
GAS ENGINE
CAUTION: Power steering fluid hoses must remain away from the exhaust system, driveshafts, vehicle components and any unfriendly surface
that can possibly damage the hoses.
1. Using a lint free towel, wipe clean the open power steering hose end and the power steering pump port. Replace any used O-rings with new.
Lubricate the O-ring with power steering fluid.
2. Install the power steering pressure hose into the engine compartment from below.
3. Install the fasteners (1) securing the power steering hose routing clamps (2) to the crossmember. Tighten the screws to 8 Nm (71 in. lbs.).
