Caliber SRT-4 L4-2.4L Turbo VIN F (2007)
10. Install the fasteners (1) securing the power steering hose routing clamps (2) to the crossmember. Tighten the screws to 8 Nm (71 in. lbs.).
11. Install the pressure hose (2) at the gear (3). Tighten the tube nut to 32 Nm (24 ft. lbs.).
12. Install the return hose (1) at the gear (3). Tighten the tube nut to 20 Nm (15 ft. lbs.).
13. Position the heat shield (3) and install the three screws (1, 2) securing the shield to the crossmember (4). Tighten the two front mounting screws
(1) to 4 Nm (35 in. lbs.). Tighten the rear mounting screw (2) to 17 Nm (150 in. lbs.).
14. Install the front engine mount through-bolt.
15. Install the rear engine mount.
16. If equipped, install the engine belly pan.
