Caliber SRT-4 L4-2.4L Turbo VIN F (2007)
Stabilizer Bar: Service and Repair
Rear Suspension
Removal
REMOVAL
NOTE: Before proceeding, refer to REAR SUSPENSION WARNING.
1. Raise and support the vehicle.
2. On both sides of the vehicle, while holding the stabilizer bar link upper stud stationary, remove the nut (1) securing the link to the stabilizer bar
(3).
3. If equipped with all-wheel-drive, remove the rear driveline module.
4. On both sides of the vehicle, remove the screws (3) securing the stabilizer bushing retainers (1) to the crossmember.
5. Remove the two stabilizer bushing retainers.