Caliber SRT-4 L4-2.4L Turbo VIN F (2007)
Wiper Motor: Service and Repair
Motor-Rear Wiper
Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the rear wiper arm from the rear wiper motor output shaft.
3. Remove the trim from the liftgate inner panel.
4. Disconnect the liftgate wire harness connector (2) from the rear wiper motor (4).
5. Remove the three screws (3) that secure the motor mounting bracket to the U-nuts (5) on the liftgate inner panel.
6. Pull the wiper motor forward far enough to disengage the output shaft from the rubber grommet (1) in the liftgate glass.
7. Remove the motor from the liftgate.
8. Remove the rubber grommet from the output shaft clearance hole in the liftgate glass and discard.
Installation
INSTALLATION
1. Install a new rubber grommet (1) into the rear wiper motor output shaft clearance hole located in the liftgate glass. Always use a new rubber
grommet in the glass.
