Caravan L4-153 2.5L SOHC (1989)
Note:
Retain tube bracket and timing cover stud nuts for reassembly.
6.
Disconnect PCV hose from cylinder head cover.
7.
Remove existing cylinder head cover, gasket and aside for parts return.
8.
Clean cylinder head rail gasket surface with Mopar Parts Cleaner PN 4318037 or equivalent.
Figure 3
9.
Apply RTV sealant to cylinder head rail (Figure 3).
10.
Attach the two supplied cylinder head cover end seals to new cover.
11.
Install the cylinder head cover assembly on the cylinder head, using the
4 supplied studs with washers at each corner of the cylinder head. Install the 5 supplied screws with washers in the remaining holes.
Install original oil filler cap on new cover.
Important:
Be sure to use the fasteners from the parts package at all locations. These fasteners have washers and a different
coating on them for improved torque retention.
Figure 4
Caution:
Be sure that the engine wiring harness is routed clear of the studs and cylinder head cover edges to avoid possible chafing
(Figure 4).
12.
Tighten the cylinder head cover fasteners to 105 in.lbs. (12 N-m) torque.
13.
Reconnect PCV hose.
