Caravan L4-153 2.5L SOHC (1989)
Ignition Lock: Service and Repair
Standard Column
1.
If equipped, disarm airbag system as described under MAINTENANCE PROCEDURES.
2.
Remove steering wheel.
Steering column cover, silencer & reinforcement removal
3.
Remove steering column cover and silencer.
4.
Remove shift indicator operating cable from slot in shift housing.
5.
Pry off wiring trough from steering column, then disconnect control lever electrical connectors.
6.
Remove screws attaching turn signal lever cover to lock housing, then lever cover.
7.
Remove washer/wiper switch assembly.
8.
Pull hider up control lever, then remove control lever sleeve to washer/wiper switch attaching screws.
9.
Rotate control lever shaft to full clockwise position, then remove shaft from washer/wiper switch.
10.
Remove turn signal/hazard switch attaching screws.
Turn signal switch replacement
11.
On all models, remove turn signal/hazard warning switch assembly by gently pulling switch up from column while straightening and guiding wires
up through column opening.
12.
Remove key lamp assembly retaining screw, then key lamp assembly.
13.
Remove retaining screws holding bearing housing to lock housing.
14.
Remove snap ring from upper end of steering shaft, then bearing housing from shaft.
15.
Remove lock plate spring and lock plate from steering shaft.
16.
Remove ignition key.
17.
Remove buzzer/chime switch attaching screws, then remove switch.
18.
Remove two screws attaching ignition switch to steering column, then remove switch by rotating it 90° and sliding from rod.
19.
Remove two screws attaching dimmer switch, then disengage dimmer switch from actuator rod.
20.
Remove two bell crank attaching screws, then slide bell crank up into lock housing until it can be disconnected from ignition switch actuator rod.
Fig. 7 Ignition lock removal. W/standard column
