Caravan L4-153 2.5L SOHC VIN K FI (1987)
Power Door Lock Motor: Service and Repair
Front Door
Front Door Assembly
REMOVAL
1.
Remove door trim panel and liner. See: Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and Repair
2.
Raise door glass with service power window switch or crank.
3.
Disconnect the power door lock electrical connector.
4.
Drill out the two (2) lock motor mounting rivets.
5.
Disconnect the lock motor link at the motor and remove the motor through the access hole.
INSTALLATION
1.
Connect the lock motor to the linkage rod.
2.
Attach the lock motor to its mounting bracket with two (2) 1/4-20 X 1/2 inch screws and nuts. Torque to 90 lb-in (11 Nm).
3.
Connect the lock motor electrical connector.
4.
Install liner and trim panel. See: Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and Repair
NOTE: If the rubber boot on the power door lock motor is twisted, the movement of the motor will be restricted.