Caravan L4-153 2.5L SOHC VIN K FI (1987)
Fig. 35 Installing circlip. Outer C/V joint
5. Apply lubricant to ball races between all sides of ball grooves.
6. Insert balls into raceway by tilting cage and inner race assembly.
7. Slide small end of boot over shaft, then place clamp over groove on boot.
8. Insert new circlip in shaft groove. Do not over expand or twist circlip during assembly.
9. Position joint housing on shaft, then engage by tapping sharply with a soft faced mallet.
10. Check to ensure snap ring is properly seated by attempting to pull joint from shaft.
11. Position boot over boot groove in housing, then install clamp.