Caravan L4-2.4L VIN B (2003)
12. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it on the discharge line fitting.
13. Reconnect the discharge line fitting to the condenser inlet port on the right side of the cooling module.
14. Install and tighten the nut that secures the discharge line fitting to the condenser. Tighten the nut to 23 Nm (17 ft. lbs.).
15. Reconnect the hoses to the transmission oil cooler fittings on the left side of the cooling module.
16. Reposition the hood latch unit to the front of the radiator closure panel crossmember.
17. Install and tighten the two screws that secure the hood latch unit to the front of the radiator closure panel crossmember. Check and adjust the hood
latch as needed. Tighten the screws to 14 Nm (123 in. lbs.).
18. Position the radiator sight shield onto the radiator closure panel crossmember.
19. Install and tighten the five small screws that secure the front fascia grille inserts to the radiator sight shield. Tighten the screws to 2 Nm (18 in.
lbs.).
20. Install and tighten the two large screws that secure the front fascia and the outboard ends of the radiator sight shield to the radiator closure panel
crossmember. Tighten the screws to 6 Nm (53 in. lbs.).
21. Evacuate the refrigerant system.
22. Charge the refrigerant system.
