dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Driver Airbag|Page 7220 > < Driver Airbag
Page 1
background image

Air Bag: Service and Repair
Driver Airbag Cover

REMOVAL

The horn switch is integral to the driver airbag trim cover. If either component is faulty or damaged, the entire driver airbag trim cover and horn
switch unit must be replaced.
1. Disconnect and isolate the battery negative cable.

WARNING:  WAIT TWO MINUTES FOR THE AIRBAG SYSTEM RESERVE CAPACITOR TO DISCHARGE.

2. Remove the driver airbag from the steering wheel (Refer to ELECTRICAL/RESTRAINTS/ DRIVER AIRBAG - REMOVAL).
3. Remove the plastic wire retainer that captures the horn switch feed pigtail wire between the upper left inflator stud and the inflator on the back of

the driver airbag housing.

4. Remove the four nuts that secure the upper and lower trim cover retainers to the studs on the back of the driver airbag housing.
5. Remove the upper and lower trim cover retainers from the airbag housing studs.
6. Remove the horn switch ground pigtail wire eyelet terminal from the upper right airbag housing stud.
7. Disengage the six trim cover locking blocks from the lip around the outside edge of the driver airbag housing and remove the housing from the

cover.

INSTALLATION

1. Install the housing into the cover. Engage the six trim cover locking blocks to the lip around the outside edge of the driver airbag housing.
2. Install the horn switch ground pigtail wire eyelet terminal to the upper right airbag housing stud.
3. Install the upper and lower trim cover retainers to the airbag housing studs.
4. Install the four nuts that secure the upper and lower trim cover retainers to the studs on the back of the driver airbag housing.
5. Install the plastic wire retainer that captures the horn switch feed pigtail wire between the upper left inflator stud and the inflator on the back of the

driver airbag housing.

6. Install the driver airbag onto the steering wheel (Refer to ELECTRICAL/RESTRAINTS/ DRIVER AIRBAG - INSTALLATION).

WARNING:  DO NOT CONNECT THE BATTERY NEGATIVE CABLE. FIRST (REFER TO ELECTRICAL/RESTRAINTS/DIAGNOSIS
AND TESTING - AIRBAG SYSTEM).

Driver Airbag|Page 7220 > < Driver Airbag