Caravan L4-2.4L VIN B (2003)
12.
Disconnect the wiring harness clip from the left front fender inner rail.
13.
Disconnect the gray 6-way wiring harness connector (Figure 2).
14.
Disconnect the rearmost Powertrain Control Module (PCM) electrical connector (Green color code) (Figure 2).
15.
Remove the transaxle wiring harness and discard it.
16.
Route the new wiring harness on the transaxle.
17.
Connect the rearmost PCM (green) electrical connector (Figure 2).
18.
Connect the gray 6-way wiring harness connector (Figure 2).
19.
Connect the wiring harness clip to the left front fender inner rail.
20.
Connect the wiring harness clip to the transaxle pan.
21.
Install the inner fender liner.
22.
Install the inner fender liner push pins and screws.
23.
Turn the front wheels back to the straight ahead position.
24.
Connect the TRS electrical connector (Figure 1).
25.
Connect the output speed sensor electrical connector (Figure 1).
26.
Lower the vehicle.
27.
Connect the input speed sensor electrical connector (Figure 1).
28.
Connect the transaxle solenoid/pressure switch electrical connector (Figure 1).
29.
Connect the negative battery cable.
