Caravan V6-181 3.0L SOHC VIN 3 FI (1987)
cover trough.
10. Using tool C-3879 or equivalent, washer and nut, install housing onto steering shaft. Remove tool and install snap ring.
11. Install the 3 bearing housing to lock housing screws and torque to 35 inch lbs.
Fig. 15 Non-tilt wheel steering column upper end exploded view (column shift auto. trans.) 1984---85 front wheel drive Mini-Vans/Wagons
Fig. 16 Non-tilt wheel steering column upper end exploded view (column shift auto. trans.)
MINI-VANS/WAGONS W/COLUMN SHIFT
DISASSEMBLY
1. Pry out wiring trough retainers and lift off trough.
2. Using a punch, drive out shift lever roll pin. Use a deep socket to receive roll pin.
3. Remove breakaway capsules and secure steering column in a vise by clamping at the column bracket.
4. Remove turn signal lever cover screws and cover, then remove the washer/wiper switch assembly.
5. Pull hider up control stalk and remove control stalk sleeve to washer/wiper switch retaining screws.
6. Rotate control stalk shaft to full clockwise position and remove shaft from switch by pulling straight out of switch.
7. Remove turn signal switch and upper bearing retainer screws, then remove retainer and lift switch upward and out of the way.
