Caravan V6-181 3.0L VIN 3 FI (1988)
INSPECTION
1.
Using suitable solvent, clean support, then inspect for burrs and remove as necessary.
2.
Clean and lubricate threads of adjusting screws, then inspect for pulled or stripped threads.
3.
If spring paint shows discoloration, end coils are distorted, or spring strength is questionable, replace spring.
INSTALLATION
Pivot screw and adjusting nut have lefthand threads on left side brakes and righthand threads on right side brakes.
1.
Using suitable lubricant, lubricate and assemble star wheel assembly, then lubricate guide pads on support plates.
2.
Assemble star wheel, lower shoe-to-shoe spring, and brake shoes and position assembly on support plate.
3.
Connect parking brake cable to parking brake lever.
4.
Install and hook hold-down springs.
5.
Install upper shoe-to-shoe spring.
6.
Position adjuster lever return springs on pivots.
7.
Install adjuster lever and route adjuster cable and connector to adjuster.
8.
Position drum on axle housing.
9.
Install bearing and inner nut.
10.
Install lock washer and outer nut, bending washer to lock in place.
11.
Place new gasket on hub and install axle shaft, cones, lock washers, and nuts.
12.
Adjust brakes.
13.
Install tire and wheel assembly.
14.
If any hydraulic connections have been opened, bleed brake system.
15.
Check fluid level in master cylinder, filling as necessary.
16.
Check brake pedal for proper feel and return.
17.
Lower vehicle and road test.
