Caravan V6-181 3.0L VIN 3 FI (1988)
Fig 16 Installing Bushings
7. Compress flanges of guide pin bushings in with fingers and work into position by pressing IN on bushings, using fingertips or plastic trim stick
until seated.
8. Be sure flanges extend over caliper casting evenly on both sides.
9. Before installing caliper assembly on vehicle, inspect braking disc.
10. Install brake hose to caliper using new seal washers.
11. Bleed the brake system.
Cleaning, Inspecting & Honing Caliper
Honing Brake Caliper Piston Bore
Inspect the piston bore for scoring or pitting
-
Bores that show light scratches or corrosion, can usually be cleared with crocus cloth.
-
Bores that have deep scratches or scoring should be honed, using Tool C-4095, providing the diameter of the bore is not increased more than
0.0254 mm (0.001 inch).
-
If the bore does not clean up within this specification, a new caliper housing should be installed. Install a new piston if the old one is pitted or
scored.
When using a hone:
Coat the stones and bore with brake fluid. After honing the bore, carefully clean the seal and boot grooves with a stiff nonmetallic rotary brush.