Caravan V6-201 3.3L (1995)
5. Engage hidden clips to hold trim to D-pillar.
6. Install screws to hold trim panel to attaching bracket on short wheel base vehicle.
7. Install quarter trim bolster on short wheel base vehicle.
8. Install bolt to hold second rear seat belt, if equipped, anchor to quarter on short wheel base vehicle.
9. Install second rear seat belt turning loop on long wheel base vehicle.
10. Install liftgate sill plate.
11. Install rear header trim cover.
Right Quarter Trim Panel-Left on Four Door
Right Quarter Trim Panel - Left On 4 Door
REMOVAL
CAUTION: Disconnect the negative cable clamp from battery post. Damage to accessory feed circuit can result.
1. Remove first rear seat.
2. If equipped, remove second rear seat.
3. Remove sliding door sill plate.
4. Remove quarter trim bolster.
5. Remove upper C-pillar trim.
6. Remove D-pillar trim panel.
7. Remove first rear seat belt anchors.
8. Remove second rear seat belt anchor.
9. Remove screws holding quarter trim to quarter panel from bolster area.
10. Remove screws holding rear edge of quarter trim to support bracket.
11. Disengage hidden clips holding front of quarter trim to quarter panel rearward of sliding door opening.
12. If equipped, disengage wire connector from accessory power outlet.
13. On long wheelbase wagon, separate quarter trim from quarter panel and pull second rear seat belt through access hole.
14. On all wagons, pull first rear seat belt through access hole.
15. Separate quarter trim panel from vehicle.
