Caravan V6-201 3.3L (1995)
INSTALLATION
1. Place quarter trim panel in position on vehicle.
2. On all wagons, insert and pull first rear seat belt through access hole in trim panel.
3. On long wheelbase wagon, insert and pull second rear seat belt through access hole in trim panel.
4. If equipped, engage wire connector into accessory power outlet.
5. Engage hidden clips to hold front of quarter trim to quarter panel rearward of sliding door opening.
6. Install screws to hold rear edge of quarter trim to support bracket.
7. Install screws to hold quarter trim to quarter panel in bolster area.
8. Install second rear seat belt anchor.
9. Install first rear seat belt anchor.
10. Install D-pillar trim panel.
11. Install upper C-pillar trim.
12. Install quarter trim bolster.
13. Install sliding door sill plate.
14. If equipped, Install second rear seat.
15. Install first rear seat.
16. Connect the negative cable clamp to battery post.
Roof Rail Module
REMOVAL
1. Remove overhead grab-handle, if equipped.
2. Pull coat hook downward and remove screw holding module to roof rail.
3. Disengage hidden clips holding module to roof rail.
4. Separate roof rail module from vehicle.
INSTALLATION
1. Place roof rail module in position on vehicle.
2. Engage hidden clips to hold module to roof rail.
3. Pull coat hook downward and install screw to hold module to roof rail.
4. Install overhead grab-handle, if equipped.
Sliding Door Sill Plate
Sliding Door Sill Plate
REMOVAL
1. Disengage hidden clips holding sill plate to sliding door opening sill.
2. Disengage hooks holding outside edge of sill plate to door sill.
3. Separate sill plate from vehicle.
INSTALLATION
1. Place sill plate in position on vehicle.
2. Engage hooks to hold outside edge of sill plate to door sill.
3. Align guide pins to holes in door sill.
4. Engage hidden clips to hold sill plate to sliding door opening sill.
Upper B-Pillar Trim Cover
