Caravan V6-201 3.3L (1995)
Seat Track: Customer Interest
Quad Seat Floor Attachment - Rattling Noise
NO: 23-74-94 Rev. A
GROUP: Body
DATE: Oct. 28, 1994
SUBJECT:
Rattling Noise from Quad Seat Floor Attachment
THIS BULLETIN SUPERSEDES TECHNICAL SERVICE BULLETIN 23-74-94 DATED OCT. 7, 1994 WHICH SHOULD BE REMOVED FROM
YOUR FILES. THE REVISION INVOLVES CORRECTION OF A PART NUMBER AND IS HIGHLIGHTED WITH **ASTERISKS**.
MODELS:
1994 - 1995 (AS) Town & Country/Caravan/Voyager
1994 - 1995 (ES) Chrysler Voyager (European Market)
SYMPTOM/CONDITION:
Rattling noise from quad seat floor attachment when driving over rough roads.
DIAGNOSIS:
Grasp the back of each quad seat and shake fore and aft and side to side. If a rattle is heard, perform the repair procedure.
PARTS REQUIRED:
4
4705758
Bumper
4
154695
Screw
2 **
4705760 **
Cap
REPAIR PROCEDURE:
This bulletin involves installing rubber bumpers on the bottom front of the quad seat risers.
1.
Unlatch and remove the quad seats from the vehicle.
2.
Locate the hole on the bottom side near the front of the quad seat risers and install a rubber bumper, P/N 4705758, on each riser (Refer to
illustration).
3.
Thread a screw, P/N 154695, into each bumper and tighten until approximately 3/4 in. of the screw protrudes through the bumper.
4.
On the left side quad seat install cap, P/N 4705760, over the protruding portion of the screws.
5.
Install the quad seats and securely latch.
POLICY: Reimbursable within the provisions of the warranty.
