Caravan V6-201 3.3L (1995)
b. Holding the convoluted end of the bushing with one hand. Push the sleeve through the bushing until the one end of the bushing is fully seaated
into the seal groove on the one end of the sleeve.
Fig 8 Installed Caliper Bushing Sleeve
c. Holding the sleeve in place work the other end of the bushing over the end of the sleeve and into the seal groove. Be sure the other end of the
bushing did not come out of the seal groove in the sleeve.
c. When the sleeve is seated properly into the bushing. The sealed for life bushing can be held between your finger and easily slid back and forth
without the bushing seal unseating from the sleeve.
NOTE: Before installing caliper assembly on vehicle, inspect braking disc for runout, thickness, and thickness variation.
7. Install caliper assembly.
CAUTION: Always use new seal washers when installing brake hose to caliper.
8. Install brake hose to caliper using new seal washers, tighten banjo bolt to 33 Nm (24 ft lb).
9. Bleed the brake system.
