Caravan V6-201 3.3L (1995)
Shock Tower To Spring Minimum Clearance Area
CAUTION: At no time when servicing a vehicle, can a sheet metal screw, bolt, or other metal fastener be installed in the strut tower to take the place of
an original plastic clip. Also, NO holes can be drilled into the front strut tower in the area shown in for the installation of any metal fasteners into the
strut tower.
Because of the minimum clearance in this area , installation of metal fasteners could damage the coil spring coating and lead to a corrosion failure of the
spring. If a plastic clip is missing, or is lost or broken during servicing of a vehicle, replace it only with the equivalent part listed in the parts catalog.
Splice Location Symbol Identification
Wiring Splice Examples
Wire Color Code Chart
Splice locations are indicated in the diagrams by a diamond with a splice circuit code within it. If there is more than one splice per circuit a small box
will be connected to it with the splice number in it.
To locate a splice in the wiring harness determine the splice number from the wiring diagrams, then refer to the splice location index. This section shows
the general location of the splice in the harness.
