Caravan V6-201 3.3L (1995)
9
Torque generator bracket to intake manifold, and cylinder head to intake manifold bolts to 54 Nm (40 ft-lbs).
10. Connect ground strap, MAP sensor, charge temperature sensor and oxygen sensor connectors.
11. Install DIS coils and torque bolts to 12 Nm (105 in-lbs).
12. Connect fuel lines to fuel rail and torque clamps to 1 Nm (10 in-lbs). Connect vacuum harness to air intake plenum and fuel pressure regulator.
13. Connect brake booster supply hose to intake plenum and connect PCV hose to plenum. Connect IAC motor and TPS electrical connectors, and
connect vacuum harness to throttle body.
14. Install throttle cable, and air inlet hose assembly. Connect negative battery cable.
NOTE: ASD and fuel pump relays remain energized for 7 minutes during the following test, unless the test is stopped or the ignition switch is
turned to the OFF position.
15. Using scan tool, place ignition switch in "RUN" position and use Actuate Output Test "Auto Shutdown (ASD) Relay", to activate fuel pump and
pressurize system.
16. Check for leaks.
